Detecting configured yum repos

[Claude Jones]

Configuring channels in Smart is a bit tedious. I discovered by chance that 
Smart when started for the first time after installation on my Fedora Core 
boxes, would often offer me the option, one by one, of including my existing 
yum repositories as channels. I can't figure out how to make this behavior 
consistent, however. In the past two weeks, I've built up a couple of new FC6 
machines. In both cases, I first configured my yum repositories, which are 
easy to do because most of the repos offer release packages which take care 
of configuration with one easy rpm installation. Once I have all my 
repositories set up, I installed smart, and on first run, Smart went through 
all the repos I'd set up, and asked one dialog at a time, if I wanted to add 
those repos as channels. Very nice. But, on my second try, this did not 
happen. I tried removing Smart and reinstalling it, but to no avail. Is there 
a command I can run that will detect the repos in /etc/yum.repos.d and offer 
me the opportunity to add them as channels? 
-- 
Claude Jones
Brunswick, MD, USA